Darth Vader Enail: Vintage Dual Unit


Darth Vader Enail: Vintage Dual Unit

This dual Darth Vader enail is made for using with two rigs or two rosin pressing plates at once. It was made from an old carrying case, so it has been used before and does show some signs of use in the exterior. This Vader shell picked up it’s share of scratches, scrapes, and scuffs over the years which adds even more vintage character, although the hinges are a little brittle. If you open and close it too many times you may have to end up taping or gluing it (or adding a hinge).


  • Cut & assembled in the USA with imported electronics
  • A word about the case – it is vintage and not the strongest at the seams or latches. The rest is fine structurally but there are quite a few scratches and scuffs around. If you’re interested in some more detail pictures just LMK and I will take some more and send them over. Another thing to take into account is the large size of this controller compared to most of the others: 17″ x 15″ x 4″
  • Free Vader flower grinder comes with if interested (just request in notes)
  • High wattage electronics are protected with a “fast blow” fuse
  • Strong, rugged, shock-resistant plastic enclosure
  • Specific wiring for RCCtools coils and certain other brands. Different wiring available by request.
  • Free 2-year warranty on each and e-nail controller

*Custom wiring order can be done by request for your heating coil if you already have one you want to use

$189.99 $179.99

Out of stock

Here are some frequently asked questions about e-nails for those may still be curious to get more beginner’s info. If you are looking for more information specifically about which enail accessories you might quickly find what you need in this guide.

Are you finding what you need?

how can I improve the site to be more helpful?

What would you like to see?

suggestions Are welcome!