Thermal Core Banger Kit (Coil, Banger, Capper, & Insert)

Thermal Core Reactor Banger:

CAUTION!!! Your e-nail will not work if the wiring does not match this coil wiring: pin1=AC, pin2=AC, pin3=TC+, pin4=TC-, pin5=GND

 

Many e-nail controllers are wired differently (even though they have the same size plug). If you are unsure, you will need to find out! Read this for more info. if you are not totally sure what I mean. You will save us both some time and pain.

Includes:

  • 25mm Axial coil
  • Thermal core 25mm banger (14mm male joint)
  • Quartz bucket insert
  • Choice of capper/dabber tool and mini stand

Specs:

    • 100W/120V coil
    • XLR 5-pin connector
    • K-type TC’s
    • Kevlar cord sheath is rip and shear resistant
    • The wiring order of this coil: pin1=AC, pin2=AC, pin3=TC+, pin4=TC-, pin5=GND

$64.99

$0.00
  • Options Price: $0.00
  • Product Price: $64.99
  • Total: $0.00

Advantages Of The Thermal Core Reactor Banger:

The heat retention properties of the thick core in this banger are what sets it apart from the others. The main advantage with a quartz core banger is more heat transfer where it counts. The dab cools down much slower due to the extra mass in the center of the banger.. This is especially nice if you are using a torch on the go. The cool down will happen slower and be much easier to catch than without the core. Also, most of the heat will concentrate right in the center of the core reactor banger, right where you want it. Putting an insert right on top really wraps up the full setup nicely! The core of the banger can also be used as a dab surface without an insert just as well. It is not much more difficult to clean than a normal flat surface, and can actually help keep the dabs from climbing up the side walls of the banger. When the dab climbs up the side it tends to reach for a cooler spot. When it hits that cooler spot it has a tendency to dry out before reaching vaping temperature, wasting the dab. The hot core helps keep the dabs in the hot zone for maximal efficiency.

A capper is necessary if taking the #lowtempdab route and highly recommended if taking the #hightempdabs route. Here is a heat coil plug wiring guide, which is essential if you want to match different brands of enail gear. If you are looking for more information specifically about which enail accessories you should really check out this guide.

Back to the Lobby

Enail and Dab Gear Info. Here

If you have any questions don’t hesitate to use the contact page and send a quick message.

stay posted on new deals and gear?

Only once in a while --
only when it's good.