Analog Enail | Noise Ripples

Analog Enail | Noise Ripples

The compact design for this analog e-nail was modeled, 3D printed, and assembled, in Portland, Oregon. The electronic circuit is about as simple as can be for temperature control. It uses the same “tech” that dims your house lights. The analog temperature control keeps temperatures within a decently precise range for dabbing temps when set at about half way. Find your sweet spot is normally a short and simple process of trying a few positions and letting it sit for a couple of minutes before dabbing. There is a more detailed explaination on how to get more exact #lowtemps for your next #dabsesh on the category page (CTRL+F and Type Yuri to skip to it). The unit is capable of delivering steady and convenient electric heat to the table.

Features and Specs:

  • Heats safely and reliably using the same simple electronics in your house lights
  • Made of sustainable PLA plastic material which is a by-product of the sugar industry. PLA is recyclable and even semi-compostable (if buried in soil for a few years or so).
  • Choose accessories below using the drop-down menus
  • 2-year warranty included on each controller
  • XLR heating coil pin configuration: pin1=AC, pin2=AC, pin3=X, pin4=X, pin5=ground


Pick Up to 3 Colors Using The Picker Field (Will Appear Below) -- Please Email With How Exact They Should Be, Thanks.
  • Options Price: $0.00
  • Product Price: $47.99
  • Total: $0.00

Care For 3D Printed Items

All 3D printed items must be handled with a reasonable level of care to avoid weakening and/or warping the structure. 3D FDM printing uses a layer-by-layer construction — as opposed to standard injection molding which has no layers but is one uniform piece. Any transport of 3D printed items requires sufficient padding and avoidance of stacking heavy objects on top of these items or around them without sufficient padding and/or bracing.

Please keep 3D printed items out of direct sunlight. Intense direct sunlight a very hot environment may result in slight warpage. Care should be taken to keep any 3D printed away from intense heat (over 90F) or the risk of warpage may increase. In most cases the warpage is very slight and hardly noticeable; but some caution is warranted regarding this.

Do you have any questions or Comments? Don’t hesitate to drop a line!

Back to the Lobby

General Dab Gear Parts Information

Are you finding what you need?

how can I improve the site to be more helpful?

What would you like to see?

suggestions Are welcome!