Open Barrel 20mm Heat Coil Replacement

$31.99

Barrel Style E-Nail Heat Coil Replacement –

YOUR E-NAIL WILL NOT WORK OR MAY EVEN MALFUNCTION DANGEROUSLY IF THE WIRING DOES NOT MATCHMany e-nail controllers are wired differently (even though they have the same size plug). IF YOU ARE UNSURE ABOUT THE WIRING ON YOUR E-NAIL PLEASE CONTACT FIRST TO MAKE SURE THIS COIL WILL MATCH! 

  • 20mm barrel style e-nail heat coil
  • 100W/120V coil
  • Standard XLR 5-pin connector
  • K-type TC’s
  • Kevlar cord sheath is rip and shear resistant

This is the wiring order of this coil: pin1=AC, pin2=AC, pin3=TC+, pin4=TC-, pin5=GND

IF YOU ARE UNSURE ABOUT THE WIRING ORDER OF YOUR CONTROLLER YOU MUST E-MAIL THEM FIRST TO MAKE SURE THIS COIL WILL WORK!!

Ask your controller seller for the pin configuration to match to this coil before purchasing! YOUR E-NAIL WILL NOT WORK OR MAY EVEN MALFUNCTION DANGEROUSLY IF THE WIRING DOES NOT MATCH! Many e-nail controllers are wired differently (even though they have the same size plug). It may look like the same size plug but some companies wire their e-nails differently to try to get proprietary exclusivity. IT IS SOLELY YOUR RESPONSIBILITY TO MESSAGE IF YOU DO NOT KNOW YOUR CONTROLLER WIRING CONFIG. ALREADY. Most e-nail sellers are responsive when you ask them. Just ask what the wiring configuration is on the 5-pin XLR plug. When you find it, please make sure it matches the listed configuration above

In stock

$0.00
  • Options Price: $0.00
  • Product Price: $31.99
  • Total: $0.00

The barrel e-nail heat coil is great for a more indirect heat (for extremely low temp #chronnoisseurs) and compatibility with other “dome-less” nails. By comparison, the flat coils are the most efficient at delivering heat directly to the dish’s bottom surface, where it is needed most, but barrel style coil will heat the side-walls slightly more than the bottom– which can lead to better flavor / more vapor than combustion. A carb cap is highly recommended if going the #lowtemp route.

If you have any questions don’t hesitate to use the contact page and send a quick message!

RCCtools has been designing and assembling top-shelf heady electric dab tools out of Portland, Oregon since early 2015, when med-cannabis was first transitioned into legal recreational use. Therefore all products on this site are intended for legal use only, by adults of legal age according to use case, but not younger than 18 (for tobacco usage). Although these products may be used for aromatherapy, for fire hazard and/or electrical-safety concerns you must be 18 or older to order.

HOME

BACK TO PRODUCT CATEGORY

Additional information

Dimensions8 × 6 × 1 in
Wiring

Standard XLR Wiring (PIN1=AC POWER, PIN2=AC POWER, PIN3=TC+, PIN4=TC-, PIN5=GROUND), "Custom" XLR Wiring