cheap analog e-nail set
affordable dab setup
affordable dab setup
affordable dab setup
cheap analog e-nail set
cheap analog e-nail set
'Illuminati' Glass American Dab Rig
cheap heady e-nail set
flat e-nail heat coil replacement 10mm inner diameter
20mm e-nail barrel heat coil
axial e-nail heat coil for 20mm banger
XLR heat coil wiring type matching diagram
electric dab e-nails for sale

Analog E-Nail & Illuminati American Rig

$106.99 $96.99

Analog E-Nail & Illuminati American Rig:



  • Heats safely and reliably to dabbing temps after just a couple of minutes (when dial is turned to “1PM”)
  • Turn the dial up a little over half-way and enjoy steady and convenient temperature controls
  • Standard XLR output so you can easily replace your heat coil later
  • Designed & assembled in Portland, Oregon
  • 2 year warranty on each e-nail controller

Only 1 left in stock

  • Options Price: $0.00
  • Product Price: $96.99
  • Total: $0.00

Can I use an e-nail with a small dab rig, mini tube/beaker, banger hanger, etc.,? My rig is really small and is prone to tipping. How do I keep my small dab rig from tipping over when I put the e-nail coil on the nail?

The main thing is to understand how the balance works with your rig. E-nail coils may add a little too much weight to the outside of the rig if the glass does not have a sturdy base or has a joint which makes the nail extend far outward instead of upward.

The good news is this is usually a simple matter to fix! Most people will naturally point the coil cable away from the rig instead of turning it inward (see diagram). This cases the dab rig to become unbalanced and tip over. Sometimes it may not immediately tip over until something moves it or until it is placed in a position which causes the cord to draw it down. In most cases if you angle the e-nail coil back inwards closer to the rig this will fix this problem.

If this doesn’t quite do it you can go a step further and get a $10 dropdown glass adapter which can lower the center of gravity so that the nail sits closer to the top of the joint. instead of high up and away from the rig. If the rig has an angled joint it may also help to get a cheap 45 degree adapter (probably male to female 14mm). This will point the nail upwards instead of outwards.

A dropdown adapter also will allow you to create a “triangular loop” that brings the weight full circle back around towards the mouthpiece and balances the rig perfectly so you need not worry about tipping rigs again!

how to prevent small dab rig from tipping diagram-01

What sets RCCtools apart from other e-nail companies? Take a look at “WHAT SETS RCC TOOLS APART?


Additional information

Weight3 oz
Dimensions7 × 4 × 4 in

You may also like…